Comments on: Tip on new Adorning Accents Edgelits Dies

By: Deb

Deb — Thu, 21 Feb 2013 15:47:46 +0000

Thank you so much Ramoa! Thank you for looking! Have a super day.

By: Ramona

Ramona — Thu, 21 Feb 2013 03:54:46 +0000

What a fabulous idea. Thanks so much for sharing it.

By: Deb

Deb — Sat, 09 Jun 2012 15:24:00 +0000

Hi Tyna, I do not own a cuttlebug but from those that I have talked to that do own it, some of our dies do work in it. Let me know if I can help in any other way! deb

By: Tyna Ashley Miller

Tyna Ashley Miller — Tue, 05 Jun 2012 20:10:16 +0000

o you know at this point if the Cuttlebug will take on Framelits? I am looking at their very new catalogs – Floral Frames Framelits, 5 layering dies, largest 5-1-4 inch wide and is #127012. Has any more feedback come through. I have extended plates for length, but still question the width?? Thank you, Tyna – on page 191 of the new Stampin Up catalog. It shows some basic "how to build a framelits sandwich, but I am still confused as to whether I can use the Cuttlebug. This company sells the BigShot, so no information about a Cuttlebug. I called S.U and they did not know this information as of yet.

By: Deb

Deb — Sun, 25 Mar 2012 16:43:59 +0000

Hi Diane,

Sorry for the delay in responding but it’s been busy busy busy during our Sale-a-Bration so my blog has been a little neglected. I only adhere one edgelit to the plate at a time but what you spend on plates, you are going to save on cardstock…the edgelits tend to move some of the time so you have to recut cardstock. I just LOVE the way these are working for my clubs, classes and continuing education. The stampers come right in and just cut without having to adjust; readjust and then readjust again!!!! They love it!!! I hope this helps, it has for me.

By: Diane Gibson

Diane Gibson — Sun, 11 Mar 2012 03:07:19 +0000

Hi Deb, I LOVE this idea, but I have a couple of questions: I'm assuming that the top plate will be turned over so the cutting edge is down on top of the cs. It will now cut into the "grid plate" and that plate will eventually have to be replaced, right? Also, could you adhere multiple edgelits to the plates? I'll bet, as popular as they have been, that SU will produce more. I'm just wondering how cost effective it would be with so many plates? I'm kind of thinking ahead. Thank you for such a great idea and for sharing.

By: Deb

Deb — Sun, 26 Feb 2012 04:57:52 +0000

I trimmed the scallop edge with my craft and rubber scissors. I hope this helps.

By: Connie

Connie — Sat, 25 Feb 2012 05:12:48 +0000

Deb - Tried this and my scallop edgelit actually bent at the ends and the edge is not straight. Was wondering if you have had any trouble with that?

By: Deb

Deb — Sun, 12 Feb 2012 02:10:11 +0000

Alison, Thank you so much! Hope it works as well for you as it has for me! No worries about them slipping or bending! Have a great day.

By: Alison

Alison — Sat, 11 Feb 2012 02:20:24 +0000

Debbie,
You are a genius! But I already knew that…thanks so much for sharing this awesome tip!